Generally, it is calculated based on a daily, weekly, monthly, or annual basis. The Load Factor can be calculated over any time of period.
Ntopng explain load software#
You can even use a software NetFlow collector at remote sites and feed them all to a central NTop. If you are not going to use SNMP, you might want to stick with just NTop and enable RRD to collect persistent data. This depends on your network setup however. When it works you get an 'NTop' tab that provides frames access to the NTop instance.
Ntopng explain load portable#
ntopng is based on libpcap / PFRING and it has been written in a portable way in order to virtually run on every Unix platform, MacOS and on Windows as well. For monitoring the entire LAN, as you mentioned in your comment, you need to take a different approach. ntopng is the next generation version of the original ntop, a network traffic probe that monitors network usage. On the otherside then, with forwarders you basically take your DNS query and hand it off to an external resolver to get an answer for you. If you want to avoid lookups for the IP addresses use sudo iftop -n. Conversely, you're left performing raw DNS, uncached lookups yourself which depending on your connection and query load could be slower in getting answers than an external resolver might. The three columns show the 2, 10 and 40 second averages. With a dynamic load, some outside factor causes the forces of the weight of the load to change. When static, the load remains constant and doesn’t change over time. Scapy is a Python program that enables the user to send, sniff and dissect and forge network packets. The total transmit/receive values are shown at the bottom. Dynamic Load The main difference between a static and dynamic load lies in the forces produced by the weight of an object. Sample load is the amount of data (or number of packets) moving across a network. ntopng yes, it’s all lowercase provides a intuitive, encrypted. This means that ntopng can (also) be used (via HTTP) to feed data into third party apps such as Nagios or OpenNMS. The global sFlow technology configuration defined on the QFabric system.
The Load Factor is calculated by dividing the total consumption of electrical energy (kWh) for a given specific time of period to the product of maximum demand (kW) and the number of hours in that period. Section author: Philippe BiondiFor power plants, the Load Factor is defined as a ratio of energy generated in a given time of period to the product of maximum load and number of hours of operation. To reduce the peak demand, shift some load from peak time to non-peak time.įor generators or power plants, the Load Factor is an important factor to find the efficiency of the power plant. And this will increase the per-unit cost of electrical energy to the consumer. If the Load factor is very low as high peak demand, the capacity of electrical energy remains inactive for a long time.
A low load factor means high maximum demand and low utilization rate.
0 kommentar(er)
